Daily Archives: June 29, 2016

How to Adjust a Wayne Dalton Torsion Spring Garage Door

If you are setting up a Wayne Dalton Torsion garage door for the first time, changing it is the last job  garage door spring replacement Denver  you will certainly do– after installing the plastic weather condition stripping. Lift the door and check the balance. If the door lifts on its own or if it is hard to pull down, you will certainly have to take a break the springs. If the door is difficult to lift, or if it is as well very easy to pull down, you will certainly have to wind the springs. You can change the spring tension on a Wayne Dalton Torsion garage door with a couple of straightforward tools.

Completely close the door.

Apply securing pliers to the track above the third roller.

Place a winding bar right into the winding cone as well as press upwards on the winding bar while loosening up the screws on the winding cone.

Meticulously adjust spring stress a quarter of a turn. Re-tighten the screws in the cone and repeat for the opposite.

Tips & Warnings

Do not adjust a lot of turns at  garage door spring replacement Denver  one time– recheck. If the door just has one spring, secure the torsion tube with securing pliers to keep the counterbalance wire on the cord drums. Do this before loosening the screws.
Once the set screws hang, be prepared to support the full blast of the torsion spring.

Comments Off on How to Adjust a Wayne Dalton Torsion Spring Garage Door

Filed under Uncategorized